Step-by-Step Guide to Installing a Liquid Soap Mixer

Do you dread the task of refilling your soap dispenser countless times? Imagine a world where liquid soap flows effortlessly at your fingertips, thanks to the marvel of a liquid soap mixer. Installing one is a simple DIY project that will transform your bathroom experience.

Step 1: Gather Your Tools

Liquid soap mixer

Screwdriver

Drill

1/2-inch NPT plug

1/2-inch NPT hose adapter

1/2-inch copper or PEX tubing (cut to the desired length)

Teflon tape

Step 2: Shut Off Water Supply and Disconnect Water Lines

Locate the water shutoff valves under the sink and turn them off. Disconnect the hot and cold water supply lines from the sink.

Step 3: Install the NPT Plug and Adapter

Apply Teflon tape to the threads of the 1/2-inch NPT plug. Screw the plug into the opening on the back of the soap mixer. Attach the 1/2-inch NPT hose adapter to the other side of the plug, also using Teflon tape.

Step 4: Connect Copper or PEX Tubing

Cut the copper or PEX tubing to the desired length. Connect one end to the hose adapter on the soap mixer and the other end to the hot and cold water supply lines under the sink. Secure the connections with a screwdriver or wrench.

Step 5: Install the Soap Mixer

Place the soap mixer over the sink hole and align the mounting holes. Insert the screws through the holes and tighten them with a screwdriver. Ensure the mixer is securely attached.

Step 6: Connect the Soap Dispenser

Connect the tubing from the soap mixer to the soap dispenser. Turn on the water supply valves and check for any leaks.

Step 7: Fill the Soap Dispenser

Pour liquid soap into the dispenser and pump it several times to prime the system. Your liquid soap mixer is now ready to use.

Enjoy the endless flow of soap at your fingertips! This DIY project will not only save you time and effort but also enhance your daily routine. Say goodbye to the frustrations of refilling soap dispensers and embrace the convenience of a liquid soap mixer.